Wireless Doorbell

You can pair transmitters with receivers one by one for a new code to get a ring tone or expand transmitter buttons/receivers.

• Please pair transmitters with receivers one by one for a new code before you install the transmitters on the door frame.
• If you have installed your transmitters on the door frame, please use the small screwdriver (included) to open the transmitter and take the front cover off, and take it close to the receiver to pair them.

Here's how to pair them

(1). Plug one receiver into a regular socket, and pick the sound you want on this receiver.

(2）. Press and hold the volume button on this receiver for 5 seconds or so, then the receiver will blink with a "ding" sound. And then push the transmitter button at the same time (within 5seconds) to pair with the receiver. Finally, you will hear the music you set.

(3). The same way to pair other transmitter buttons with receivers.

If the doorbell rings randomly, the frequency must be being interfere by other doorbell from the same supplier.

You just need to clear the code of the receiver, and pair it with transmitter again for a new code. follow the steps:

(1). Press and hold the Forward Button of receiver for 5 seconds or so till it blink with "ding' sound to clear the code.

(2). Pair them to the transmitters that need to control the receivers one by one again to get a new code.

See Here's how to pair them step (1)-(3).

If you have two transmitters for two doors, you can set different ringtone depend on which transmitter is activated.

1. For the front door (transmitter A) - Pair it to all of receivers one by one to get ringtone # A. See step (1)-(3). all of receivers can ring at once when transmitter A is activated.
2. For the back door (transmitter B) - It's the same way to pair it to all receivers one by one to get ringtone # B.

Tips: Pairing the devices and selecting doorbell sound is easier if done before installing the transmitter buttons.